ZS-120W CO2 laser power supply 120Watt HV CO2 PSU air cooling 110/220V input 120watt laser power source

rubylasertech

ZS-120W CO2 laser power supply

Feature:

1.This 220vLaser Power Source has stable working performance: Each 120w Laser Power Source has been much more testing procedures and under full load high temperature (52~55 degrees celsius) 24 hours of aging, which ensure the stability of each CO2 laser power source.

2.This analog signal Laser Power Source has easy control: The 120w Laser Power Source uses high or low level for control. The use of TTL-level control can realize start and stop quickly. At the same time the HV Laser Power Source has a protection switch, testing is made by external water and ventilation

3.The analog signal Laser Power Source has very good protection feature: The 120watt Laser Power Source has open circuit protection to make this HV Laser Power Source works for a short time in the open state, so as to make it avoid the laser tube broken.

4. The 120w Laser Power Source has good compatibility : This HV Laser Power Source can drive EFR,Yongli, SPT,Weiju and other brand 1450mm,1400mm or 1500mm 120Watt glass laser tube,besides this feature, the Hv Laser Power Source also has strong adaptability and fast response, engraving or cutting benefits good effect.

5.The laser power control is simple, the 220v Laser Power Source can uses 0-5V analog signal or PWM signal for laser power control.

6.The 120w Laser Power Source selects ordinary H/L/P/G/IN/5V port to receive control signal. And black steel outside shell is used on this analog signal Laser Power Source.


7. It uses the latest silicon carbide to replaces traditional transistors. The silicom carbide has high efficiency, low heat generation and low failure rate characteristics.Which make the 120W HV CO2 laser PSU more suitable for long-time uninterrupted works in hot environment.
8.The silicon carbide reduces circuit's quantity, which reduces failure rate and keep consistency in output parameters. Enable 120W CO2 laser power supply have better engraving and cutting effects
9. It adopts patch assembly process, which is fully automated and standardized It uses HD cameras to detect circuit boards, assembled components and soldering effects. The two methods reduces the possibility of human error causing unqualified 120W laser power source.
10. It adopts silicone tube to wrap output HV cable to prevent electric sparks from splashing and protect operators and equipment, which allowing co2 cutting power supply work normally in humid environments
11. 90-270V Voltage stabilizer is optional.



00 wire connection.jpg

Specification：



Input

Input voltage

AC220V±10% (AC110V specified while order)


AC frequency

47~440HZ


Maximum input power

820W


Maximum input current

3.7A

Output

Maximum output voltage

35KV


Maximum output current

35mA

(depending on the laser tubes of different manufacturers)

Efficiency

More than 90% (Full load)

Response speed

Not more than 1ms

Control lnterace

TTL multilevel switching control,effective level can be high and low selection (see control wining diagram)

Insulation

lnput-output

AC 1500V 1 minutes not more than 10mA


lnput-shell

AC 1500V 1 minutes not more than10mA


Output-shell

Connection

Open Circuit Protection

Can be short circuit (requires a good grounding shell,while avoiding the positive electrode and the shell between the arc)

Environmental Requested

Working temperature

-10℃~50℃


Storage of temperature

-20℃~75℃


Relative Humidity

Maximum 85%RH (non-condensing)


Altitude

100,000 feet of work

200,000 feet of storage,dose not work

Cooling methods

Forced air cooling (fan cooling)

Dimensions (LxWxH)

230mmx142mmx95mm